The Shotmaker insert is made with ultra-thin-ply graphite. It is paper thin and extremely fragile. User must handle it with care. It will break if it is bent or squeezed by hand. Its only authorized usage is described below. All unauthorized usage will cause breakage. Harrison does not warrant the insert against breakage due to unauthorized use or accidental breakage. Each model of insert is designed to fit certain shaft models, but not all. Please check with your golf professional or Harrison for compatibility.

Opening a Grip Cap Hole:

Push the grip lock into the grip cap hole. Collapse the telescoping tool and use the hex tip of the insert tool to engage the grip lock screw. Tighten the screw by turning the black color section of the tool handle clockwise until the grip lock is secured.

Removing Grip Lock:

Use the insert tool to engage the grip lock screw. Turn the yellow tool handle counter-clockwise to loosen it. Remove the grip lock by hand.

Removing Insert:

Insert the fully extended tool inside the golf shaft to engage the insert screw. Turn the yellow tool handle counter-clockwise until the screw is disengaged. Lower the grip end of the club allowing the screw to drop out. Reinsert the tool until it contacts the insert. Turn the yellow handle clockwise 3 full turns to engage the insert. Pull out the insert.  To cover the grip cap hole, reinstall the grip lock and lock it in place.  

Reinstall the insert screw back into the locking end of the insert. Tighten it very lightly by hand. Place the insert inside its clear protective tube and cap both ends.